Michael Schwingen a écrit :
> Cyril Humbert wrote:
>> Wifi board is cm10 from Unex (http://www.unex.com.tw/product/cm10).
>> According to http://madwifi.org/wiki/Compatibility/Unex#CM10, this board
>> is fully supported by madwifi driver.
> 
> I don't know about the relationship between Unex and Wistron, but I have a Wistron CM10(DCMA-81) working
fine in my IBM Thinkpad using Madwifi.
> 
> cu
> Michael
> 

Hello,

Using a miniPCI to PCI adapter, I've tested the Wifi board on my 
development PC (Debian/unstable for AMD64) and ath_pci is properly 
initialized.

[Debian/unstable, dmesg]
(../..)
MadWifi: ath_attach: Switching rfkill capability off.
wifi0: Atheros AR5414 chip found (MAC 10.5, PHY SChip 6.1, Radio 6.3)
ath_pci: wifi0: Atheros 5413: mem=0xfdbe0000, irq=16
(../..)

Thus the problem occurs only on the Xscale CM-X270 target board?
  * PCI problem?
  * cross-compilation issue?
  * ...

Additional infos (from the PC)
==============================

[Debian/unstable AMD64]
% apt-cache show madwifi-modules-2.6.25-1-amd64 | grep "^.*:"
Package: madwifi-modules-2.6.25-1-amd64
Status: install ok installed
Priority: optional
Section: non-free/net
Installed-Size: 1480
Maintainer: Debian madwifi team 
<pkg-madwifi-maintainers <at> lists.alioth.debian.org>
Architecture: amd64
Source: madwifi (1:0.9.4+r3772.20080716-1)
Version: 1:0.9.4+r3772.20080716-1+2.6.25-1
Depends: madwifi-tools (>= 1:0.9.4~rc2+dfsg-1)
Recommends: wireless-tools, linux-image-2.6.25-1-amd64
Description: modules for the Multiband Atheros Driver for WiFi (kernel 
2.6.25-1-amd64)

[Debian/unstable]
% sudo lspci -vv -d 168c:001b
04:08.0 Ethernet controller: Atheros Communications Inc. AR5413 
802.11abg NIC (rev 01)
	Subsystem: Wistron NeWeb Corp. Device 1600
	Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR- INTx-
	Latency: 96 (2500ns min, 7000ns max), Cache Line Size: 64 bytes
	Interrupt: pin A routed to IRQ 16
	Region 0: Memory at fdbe0000 (32-bit, non-prefetchable) [size=64K]
	Capabilities: [44] Power Management version 2
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA 
PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 PME-Enable- DSel=0 DScale=2 PME-
	Kernel driver in use: ath_pci
	Kernel modules: ath_pci, ath5k

% sudo ath_info fdbe0000
  -==Device Information==-
MAC Version:  2424  (0xa0)
MAC Revision: 5414  (0xa5)
Device type:  3
5GHz PHY Revision: SChip (0x63)
2GHz PHY Revision: SChip (0x63)

/============== EEPROM Information =============\
| EEPROM Version:   5.3 | EEPROM Size:  16 kbit |
| EEMAP:              2 | Reg. Domain:     0x60 |
|================= Capabilities ================|
| 802.11a Support:  yes | Turbo-A disabled: no  |
| 802.11b Support:  yes | Turbo-G disabled: no  |
| 802.11g Support:  yes | 2GHz XR disabled: no  |
| RFKill  Support:  yes | 5GHz XR disabled: no  |
| 32kHz   Crystal:  no  |                       |
\===============================================/
(../..)
-----------------------------------------------------------------------

Best Regards,
-- 
Cyril

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/